Draytek Vigor2962 Series 빠른 시작 매뉴얼 - 페이지 9
{카테고리_이름} Draytek Vigor2962 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draytek Vigor2962 Series 18 페이지. 2.5g security vpn router
Draytek Vigor2962 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (18 페이지)
페이지 인쇄
On
Right
Off
Interface
Reset
P1
P2 (Left)
P2 (Right)~P4
P5~P6
USB1~2
Note 1
P1 to P4 port can be configurable as WAN / LAN interface. At least, up
to two of them can be set as the WAN port at one time.
For Vigor2962P, P1, P4, P5 and P6 also can be connected by PoE
equipments.
Note 2
The PoE Power budget is up to 60W.
The Ethernet link is established on
corresponding port with 1Gbps.
The Ethernet link is established on
corresponding port with less than 1Gbps.
Description
The Factory Reset button is used to restore the default
settings. Turn on the router (ACT LED is blinking). Press
the hole and keep for more than 5 seconds. When you see
the ACT LED begins to blink rapidly than usual, release the
button. Then the router will restart with the factory
default configuration.
Connector for local network devices (LAN) or a modem for
accessing Internet (WAN).
Connector for SFP module with the rate of 1G bps.
Connectors for remote network devices or local network
devices (WAN/LAN) with the rate of 1G/100M/10M bps.
Or connector for a modem for accessing Internet (WAN).
Connectors for local network devices (LAN) with the rate
of 1G/100M/10M bps.
Connector for the USB device.
Connector for a power cord.
ON/OFF - Power switch.
3