Electrolux CRYSTAL LOGIC 사용 설명서 - 페이지 7
{카테고리_이름} Electrolux CRYSTAL LOGIC에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux CRYSTAL LOGIC 11 페이지.
페이지 인쇄
METHOD OF MAINTENANCE
The following cases are not faults
1． There is water injection in time of washing or rinsing，
exchanges water level automatically．
2． There is the phenomenon of intermittent spinning in the beginning of spinning，
effects．
3．
In the course of spin，
the program return to the wash program．
of load in the spin tub．
4. There is water sound from Spin Tub. This is because there is balancing liquid in Spin Tub Balancer ring. It is for reducing
vibration of spinning.
5. Control panel remains warn after Power is switched OFF. This is due to heat in electrical parts below Control Panel.
Method Of Maintenance
After the whole washing program
The washing machine will give Buzzer sound
after any program operation to remind you of
out the load or going on with other operations.
After finishing washing，
please shut off the tap，
out the plug in case of water leakage or fire accident．
Cleaning the water inlet
After long time use，
the water inlet mesh bag may
be blocked with smudginess， a nd should be
cleaned according to the following steps：
1．
Switch on the power，
followed by shutting off the tap ．
2．
Let the washer works for 5 seconds so that water
flows into the tub through the water inlet hose．
off the power．
3．
Unload the water inlet hose and clean the mesh
bag, then restore the water inlet assembly．
which is due to that the washer senses the inadequacy of water and
which is performed to achieve better spinning
Because that is designed to rectify the unbalanced distribution
Maintenance of shell
Use soft cloth to wipe off the water
and dirt on the surface each time
after use of the washing machine．
Detergent， p ropellant and other
chemicals are not allowed to use，
pull
for they can cause damage to the
surface．
Cleaning of the lint filter
After using the washing machine for a period，
clean it according to the following steps：
1．
Take out the lint filter．
2．
Turn the mesh bag outside and wash it clean in the
water.
then turn
3．
Restore it and refix it．
TROUBLE SHOOTING
please