Electrolux EFLS210TIW 사용 및 관리 매뉴얼 - 페이지 8

{카테고리_이름} Electrolux EFLS210TIW에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EFLS210TIW 22 페이지. Front load dryer
Electrolux EFLS210TIW에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (33 페이지)

페이지 인쇄

Operating Instructions

STEPS

4. Press the

power

button and

select the

appropriate

cycle and

settings for

each load.

Add cycle

options as

desired.

5. Close the

dryer door

and start

the drying

cycle.

6. Remove

items when

done.

7. Clean the

lint filter

and empty

the water

container.

• See Cycle Selection, Cycle Settings, and Cycle

Options for detailed descriptions of cycle controls.

• See Settings Chart to determine which settings are

available for each cycle.

• To provide the best care, not every setting or op-

tion is available with every cycle. If attempting to

select an unavailable setting or option for any given

cycle, a beep will be heard and the corresponding

setting/option LED will not light. See Settings Chart

for information of available options for each cycle

by model.

• To start the drying cycle, close the door and press

the start/pause button.

• To add an item to the dryer drum, press start/

pause. The estimated remaining cycle time will be

shown in the display. The LED above the start/

pause button will blink indicating that the cycle has

been paused. Opening the door with a cycle run-

ning will also pause the cycle. Add the item, close

the door and press start/pause again to resume

the cycle.

• To change the cycle and/or settings once the cycle has

begun (after the start button has been pressed), either

rotate the knob to the reset position (12 o'clock posi-

tion) OR press the power button to turn off the unit

and cancel the cycle. Press the power button again to

turn on the unit. Select the new cycle and/or settings,

and press start/pause to begin. Changing a cycle se-

lection without canceling the current cycle WILL NOT

change the cycle.

NOTE: There is an exception if the start button has

been pressed to begin a cycle and the delay start

function is activated and counting down. In this case,

during the delay start countdown, the cycle can be

paused and cycle settings can be changed. Then

press start/pause again to resume the delay start

countdown.

• To cancel a cycle, turn the knob to the reset

position (12 o'clock position) OR press the power

button to turn off the unit.

• A signal will sound at the end of the cycle if the

mute sound option is not activated.

• Immediately remove items when the cycle is

completed and hang or fold.

• See Care and Cleaning section of this instruction.

• CLEAN LINT will be displayed at the end of the

cycle as a reminder to remove lint from filter.

• EMPTY WATER CONTAINER will be displayed at

the end of the cycle as a reminder to completely

drain the container. This message may also be

illuminated during the cycle if the container

becomes full.

TIPS

IMPORTANT

DO NOT over-dry.

Over-drying can

cause wrinkles,

shrinkage, lint, and

a build up of static

electricity.

When drying a single

large or bulky item,

such as a comforter,

pause the cycle part

way through to turn

the item "inside out"

and maximize drying

effectiveness.

ALWAYS CLEAN

LINT FROM FILTER

and DRAIN WATER

CONTAINER at

the end of each

cycle (see warning

on previous page).