Electrolux EIFLS60LSS0 사용 및 관리 매뉴얼 - 페이지 11
{카테고리_이름} Electrolux EIFLS60LSS0에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EIFLS60LSS0 30 페이지. Iq-touch front-load washer
Electrolux EIFLS60LSS0에 대해서도 마찬가지입니다: 지침 (2 페이지)
페이지 인쇄
Operating
Instructions
OPERATING
YOUR WASHER,
continued
.
Select
the
appropriate
cycle
and
settings
for
the
load.
Turn the cycle selector knob in either direction
to select the cycle desired. The indicator for
that cycle will be illuminated. See the "Cycle
Selection" section in this guide for descrip-
tions of each cycle.
The estimated cycle time, suitable wash and
rinse water temperatures,
final spin speed, soil
level, and options for each cycle will be indi-
cated for the cycle selected. See the "Cycle
Settings" and "Washer Settings Chart" in this
guide for descriptions and available settings
for each cycle.
To change the settings, press the tempera-
ture, spin speed, soil, and options
buttons to
scroll to the desired settings.
To select or delete an option, press the button
for that option. The indicator will light when
the option
has been selected. It will no longer
be lighted when the option
has been deleted.
Adjustments
to a cycle will be remembered
and recalled each time that cycle is selected in
the future.
(¢ @ '_
.................
@_:s °_'
To return to factory settings,
press these two buttons at the
same time and hold until the
signal sounds.
7. Start the washer.
Close the door and press start. The washer
will not operate with the door open and DOOR
E}PETIwill be displayed.
Select delay start to delay the beginning of
the cycle for up to 22 hours if desired.
As a safety measure, the door will automati-
cally lock during the entire wash cycle.
To add a forgotten item to the washer any time
during the wash portion of the cycle, press
pause. When the door unlocks, open the door,
add the item, close the door and press start to
resume the cycle.
If changes to the settings or options are at-
tempted after the cycle starts, you will hear
several beeps when the buttons are pressed.
To change the settings or options, press pause,
make the new selections and press start again.
To change the cycle once the cycle has begun,
press cancel, select a new cycle, and press
start again. Just turning the cycle selector
knob will not change the cycle.
To stop the cycle, press cancel.
A signal will sound at the end of the cycle if the
chime option has been selected.
Remove items from the washer when the cycle
ends and place in dryer, line dry or dry flat as
directed on the fabric care label.
For best
results
Follow the fabric care label instructions
on items to be washed.
Excess wrinkling, color transfer or odors may
develop in items left in the washer after the
cycle has ended, if not removed promptly.