Bdcom S2956 series 하드웨어 설치 매뉴얼 - 페이지 6

{카테고리_이름} Bdcom S2956 series에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bdcom S2956 series 19 페이지.

Chapter 2

2.1

Similar to other electronic products, the semiconductor chip easily gets damaged if you

power on and off abruptly and frequently. To restart up the switch of S2956, you have

to open the power on-off three or five seconds after the power is cut off.

Avoid severe collision or falling down from the height to protect the parts in the switch.

Use correct outside ports to connect the switch of S2956. Do not insert the Ethernet

plug into the console port (RJ45 8-line socket). Similarly, do not insert the console

cable into the console port (RJ45 8-line socket).

Note:

1) When you plug or dial out the power line, keep the power line horizontal with the

power socket.

2) When the lifetime of our products ends, handle them according to national laws

and regulations, or send these products to our company for collective processing.

2.2

Keep dustless and clean during or after the installation.

Put the cover at the safe place.

Put tools at the right place where they are not easily falling down.

Put on relatively tight clothes, fasten the tie or scarf well and roll up the sleeve,

avoiding stumbling the chassis.

Put on the protective glasses if the environment may cause damage to your

eyes.

Avoid incorrect operations that may cause damage to human or devices.

The safety notices mentioned here means that improper operation may lead to body

damage.

Read the installation guide carefully before you operate the system.

Only professionals are allowed to install or replace the switch.

Installation Preparation

S2956 Hardware Installation Manual

- 4 -