Bosch HBC86P7 3 Series 사용 설명서 - 페이지 18

{카테고리_이름} Bosch HBC86P7 3 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch HBC86P7 3 Series 40 페이지.

Bosch HBC86P7 3 Series 사용 설명서
Area
Cleaning agents
Oven
Hot soapy water or a vinegar solution:
Clean with a dish cloth and dry with a
soft cloth.
If oven is very dirty: use oven cleaner,
but only when oven is cold. It is best to
use a stainless-steel sponge.
Glass cover for the
Hot soapy water:
oven light
Clean with a dish cloth.
Control panel/outer
Glass cleaner:
door panel
Wipe dry immediately using a soft cloth.
Do not use a glass scraper.
Inner door glass
Glass cleaner:
Wipe dry with a soft cloth. Do not use a
glass scraper.
Seal
Hot soapy water:
Clean with a dish cloth, do not scour.
Do not use a metal or glass scraper for
cleaning.
Accessories
Hot soapy water:
Soak and clean with a dish cloth or a
brush.

Cleaning the glass panels

The glass panels can be removed from the oven door for
cleaning.
ã=
Risk of burns!
Do not remove the panels immediately after switching the
appliance off. The oven must be cold.
Removal
Open the oven door.
1.
Undo the two screws on the door using a flat-bladed
2.
screwdriver (blade width 8-11 mm). Hold the door panel
firmly while doing this. (Fig. A).
Close the door slowly and pull out the panel upwards by the
3.
door handle. (Fig. B)
$
Hold the intermediate panel firmly and press the safety catch
4.
on the door upwards. Lift out the panel upwards. (Fig. C).
&
Notes
Clean the glass panel with glass cleaner and a soft cloth.
Do not use any sharp or abrasive agents. The glass scraper
is not suitable.
18
%
Refitting
Grip the upper section of the intermediate panel with both
1.
hands and insert it into the guide at the bottom. (Fig. A).
Note: Make sure that the panel is aligned evenly, at the
bottom.
The lettering must be positioned in the top right corner, so
2.
that it can be easily read. (Fig. B).
$
Push the safety catches downwards. (Fig. C).
3.
&
Insert the door panel into the guide with both hands. (Fig. D).
4.
Push the door panel downwards, lift it slightly and hook it in
5.
at the top. (Fig. E).
'
Make sure that the door panel is sitting flush with the control
panel.
Fully open the door, while holding the panels firmly with one
6.
hand. (Fig. F).
%
(