Electrolux ELTW20XAKW0 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Electrolux ELTW20XAKW0에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ELTW20XAKW0 20 페이지.

Installation
Instructions
Leveling
your
washer
Excessivenoise and vibration can be prevented by properly
leveling the washer.
1. With the washer within 4 feet (1 m) of its final location,
place a level on top of the washer.
2. Use adjustable pliers to adjust the leveling legs so the
washer is level front-to-rear and side-to-side, and stable
corner-to-corner.
3. Pressdown on alternate corners and sides and feel for the
slightest movement. Adjust the appropriate leg(s) so the
washer sits solidly on the floor on ALL four legs. Keep the
leveling leg extension at a minimum for best performance
of the washer.
Connecting
inlet
water
1. Run some water from the hot and cold faucets to flush the
water lines and remove particles that might clog the water
valve screens and to determine which faucet is hot and
which is cold supply.
2. Remove the inlet hoses and rubber washers from the
plastic bag located in the drum of the washer and install
the rubber washers in each end of the inlet hoses.
RUBBERWASHERS
.... \,_ ,,
MUST BE PRESENT
\
USE ONLY
NEW HOSES
3. Connect the HOT inlet hose to the HOT inlet connection
on the washer and the COLD inlet hose to the COLD
inlet connection on the washer. Tighten by hand until
snug. Then tighten each supply connection another 2/3
turn with pliers. Do not cross thread or over-tighten these
connections.
4. Connect the HOTinlet
hose to the HOTwater supply and
the COLD inlet hose to the COLO water supply. Tighten
by hand until snug. Then tighten each supply connection
another 2/3 turn with pliers.
5. Turn on the water and check for leaks.
a
b
16