Electrolux EPPWELGFB 매뉴얼 - 페이지 12

{카테고리_이름} Electrolux EPPWELGFB에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EPPWELGFB 28 페이지.

페이지 인쇄

•

Carefully remove the protective film from the outer

panels without tearing it, to avoid leaving traces of

glue (Figure 8). .

Figure 8 Removing the film

•

Adjust the equipment by turning the special adjust-

able feet and making sure it is perfectly level, both

lengthwise and crosswise (Figure 9).

Figure 9 Feet adjustment

Disposal of packing

All materials used for packing are environmentally

compatible. They can be safely kept, and recycled or

burnt in a special waste incineration plant. Plastic parts

subject to possible recycling are marked as follows:

polyethylene:

polypropylene:

polystyrene

foam:

Parts in wood and cardboard can be disposed of

respecting the current regulations in the country of

use.

Plumbing connections

Install the appliance water filling and drain pipes

according to the plumbing circuit and installation dia-

grams given below.

•

Connect the appliance water supply pipe "HWI"

(see paragraph F6.2 Installation diagrams) to the

mains, fitting a cut-off cock "X", the filter provided

"Y" and a pressure gauge "Z" between the appli-

ance and the mains (Figure 10). Carefully seal all

the components to prevent leaks in the pipes.

outer wrapping, instruc-

tion booklet bag.

roof packing panels,

straps.

corner protectors.

Figure 10 Feed pipe connection

•

Check that the dynamic water supply pressure,

measured between the appliance and the main, is

between 50 and 700 kPa (test while appliance

tank or boiler is filling with water).

If the pressure is too high, fit a suitable pres-

sure reducer on the inlet pipe.

•

Connect the waste outlet pipe "D" (see paragraph

F6.2 Installation diagrams) to the main drain pipe,

fitting a trap, or place the outlet pipe over an S trap

set into the floor.