Electrolux EW 1000 I 사용 설명서 - 페이지 26

{카테고리_이름} Electrolux EW 1000 I에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EW 1000 I 28 페이지. Electrolux instruction manual compact washer ew 1000 i

페이지 인쇄

Building-in

This appliance has been designed to be built into the

kitchen furniture.

The recess should have the dimensions shown in picture

Preparation and assembly of the door

The machine is originally pre-arranged for the assembly

of a door opening from right to left.

In this case it is sufficient to screw in the hinges (1) and

the counter-magnet (6) provided with the appliance, at

the right level (Fig. B).

a) Door

The dimensions of the door should be:

- width

595-598 mm

- thickness 16-22 mm

The height (C-Fig. C) depends on the height of the

adjacent furniture's base.

b) Hinges

To mount the hinges it is necessary to drill two holes

(dia. 35 mm, depth 12.5-14 mm depending on the depth

of door furniture) on the inner side of the door. The

distance between the holes hobs fixing centres must be

416 mm.

The distance (B) from upper edge of the door to the

centre of the hole depends on the adjacent furniture's

dimensions.

The required dimensions are given in the picture C.

The hinges will be fixed to the door by means of screws

for wood (2-Fig. B) supplied with the appliance.

c) Mounting the door

Fix the hinges (1) to the machine by means of the M5x8

screws (3-Fig. B). The hinges can be adjusted to

compensate for possible uneven thickness of the door.

To align the door perfectly it is necessary to loosen the

screw (3-Fig. B), adjust the door and tighten the screw

again.

d) Counter-magnet (6)

The appliance is pre-arranged for a magnetic closure of

the door. To enable a correct operation of this device, it

is necessary to screw the counter-magnet (6) (steel disk

+ rubber ring) into the inner side of the door.

Its position must correspond to the magnet (4) on the

appliance (see picture D).

f the door has to be opened from left to right, invert the

position of the plates (7), the magnet (4) and the plate

(5) (Fig. B and E). Mount the countermagnet (6) and the

hinges (1) as previously described.