Draytek VigorSwitch P2260 빠른 설치

{카테고리_이름} Draytek VigorSwitch P2260에 대한 빠른 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Draytek VigorSwitch P2260 2 페이지. Draytek vigorswitch p2260: quick start
Draytek VigorSwitch P2260에 대해서도 마찬가지입니다: 사양 (4 페이지)

페이지 인쇄

Packing List:

Before you start installing VigorSwitch P2260, please verify that the package

contains the following items:

VigorSwitch P2260

Power Cord

Console Cable

Rubber Feet

Rack Mount Kit

Please notify your sales representative immediately if any of the items is missing or

damaged.

Power Requirements:

Voltage

Frequency

Consumption

Quick Installation:

Install the switch in the rack with mounting accessory.

Connect the switch to an AC power source.

The port 1–24 connector is RJ-45 jack on the switch. Use Category 5 UTP

cable to connect between the switch and end station.

The port 25, 26 includes two types of media --- TP and SFP fiber modules;

they support TP or fiber with auto-detected function.

Use RS-232 interface to pre-configure the switch for network management.

For example: IP address, VLAN, Port Trunking, STP, etc.

The default settings for switch's serial port are listed as follows:

Baud rate

Stop bits

Data bits

Parity

Flow control

The default values of the switch are listed as follows:

IP Address/Subnet Mask/Default Gateway: Assigned by DHCP Server

Username

Password

User also can use telnet or web to pre-configure the switch with the default IP

address and username/password in the first configuration.

Read Me First

AC Line

: 100∼240 VAC

: 50∼60 Hz

: Max. 12W (in case no PD device connected)

: Max. 185W (up to 15.4W for 12 ports, or up to 7.7W

for 24 ports

57600

none

: admin