Electrolux EW 1044 S 지침 책자 - 페이지 19

{카테고리_이름} Electrolux EW 1044 S에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EW 1044 S 21 페이지. Electrolux washing machines

Emergency emptying out

If the water is not discharged (outlet pump is

blocked, filter or drain hose are clogged), proceed as

follows to empty out the machine:

• pull out the plug from the power socket;

• close the water tap;

• if necessary, wait until the water has cooled down;

• place a bowl on the floor;

• put the drain hose end into the bowl and let the

water come out.

Should it not be possible to have access to the outlet

hose because, for example, the appliance is built in

the kitchen furniture, slightly loosen the outlet filter

after placing a bowl on the floor, to let the water

come out slowly.

At the end screw the filter again.

If the machine is installed in a place where the

temperature could drop below 0°C, proceed as

follows:

• Close the water tap and unscrew the water inlet

hose from the tap.

• Place the end of the drain hose and that of the inlet

hose in a bowl placed on the floor.

• Select programme "N" and run it until the machine

stops.

• Remove the plug from the socket.

• Screw the water inlet hose back on and put the

drain hose back in its place.

By doing this, any water remaining in the machine is

removed, avoiding the formation of ice and,

consequently, breakage of the affected parts.

When you use the machine again, make sure that

the ambient temperature is above 0°C.