Electrolux EW 1050 F 지침 책자 - 페이지 14

{카테고리_이름} Electrolux EW 1050 F에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EW 1050 F 24 페이지. Electrolux washing machines

페이지 인쇄

8. Select the DELAY START

Before you start the programme, if you wish the

starting to be delayed, press the DELAY START

button repeatedly, to select the desired delay. The

relevant light illuminates.

9. Start the programme

To start the selected programme, press the START

PAUSE button; the corresponding light stops

flashing.

The WASHING light illuminates.

The door light comes on to indicate that the door is

locked. The machine starts operating.

10. Altering a programme

You can alter the programme before it starts.

When the programme has started, you can only

reset it by turning the programme selector dial to O

and then you can select the new programme.

The washing water remains in the tub.

Start the new programme by depressing the START

PAUSE button.

If you have chosen a

delayed start, the

machine will begin the

countdown.

11. Interrupting a programme

Depress the START PAUSE button to interrupt a

programme which is running, the corresponding light

starts to flash. Depress the button again to restart

the programme.

12. Cancelling a programme

Turn the selector dial to O to cancel a programme

which is running. Now you can select a new

programme.

13. Opening the door after the

programme has started

First set the machine to PAUSE by pressing the

START PAUSE button.

The door can be opened when the light of the

porthole has gone out.

If the door does not open, this means that the

machine is already heating, that the water level is

above the bottom edge of the door or that the drum

is turning.

If you cannot open the door but you need to open it

you have to switch the machine off by turning the

selector dial to "O". After about 2 minutes the door

can be opened (pay attention to the water level and

temperature!).

14. At the end of the programme

The machine stops automatically.

If the RINSE HOLD option has been selected, the

phase light END and the light on the porthole are on

to indicate that the water must be emptied out before

opening the door.

To do this first turn the programme selector dial to

"O" and then to drain programme

programme

. The spin speed

reduced with the relevant button

to avoid any creasing if you have washed delicate

items.

The door can only be opened after the light of the

porthole has gone out.

Release of the lock is also indicated by the coming

on of the END light.

Turn the programme selector dial to "O" to switch the

machine off.

Remove the laundry from the drum and carefully

check that the drum is empty.

If you do not intend to carry out another wash, close

the water tap. Leave the door open to prevent the

formation of mildew and unpleasant smells.

or spin

must be