Electrolux EW 1062 S 설치 및 사용 설명서 - 페이지 20

{카테고리_이름} Electrolux EW 1062 S에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EW 1062 S 22 페이지. Front-loading washing machine
Electrolux EW 1062 S에 대해서도 마찬가지입니다: 설치 및 사용 설명서 (23 페이지)

페이지 인쇄

4. Water inlet filter

If you notice that the machine is taking longer to fill,

check that the filter in the water inlet hose is not

blocked.

Turn off the water tap.

Unscrew the hose from the tap and remove the filter.

Clean it with a stiff brush.

Refit the filter and screw the hose back onto the tap.

5. Emergency emptying out

If the water is not discharged (outlet pump is blocked,

filter or outlet hose are clogged), proceed as follows to

empty out the machine:

• pull out the plug from the power socket;

• close the water tap;

• if necessary, wait until the water has cooled down;

• place a bowl on the floor;

• put the outlet hose end into the bowl and let the

water come out.

Should it not be possible to have access to the outlet

hose because, for example, the appliance is built in

the kitchen furniture, slightly loosen the outlet filter

after placing a bowl on the floor, to let the water come

out slowly.

At the end screw the filter again.

6. Frost precautions

If the machine is installed in a place where the

temperature could drop below 0°C, proceed as

follows:

• Close the water tap and unscrew the water inlet

hose from the tap.

• Place the end of the outlet hose and that of the inlet

hose in a bowl placed on the floor.

• Select the draining programme N and run it until the

machine stops.

• Switch the machine off.

• Remove the plug from the socket.

• Screw the water inlet hose back on and put the

outlet hose back in its place.

By doing this, any water remaining in the machine is

removed, avoiding the formation of ice and,

consequently, breakage of the affected parts.

When you use the machine again, make sure that the

ambient temperature is above 0°C.

P0041