Electrolux EW 550 F 지침 책자 - 페이지 5

{카테고리_이름} Electrolux EW 550 F에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EW 550 F 18 페이지. Electrolux washing machines
Electrolux EW 550 F에 대해서도 마찬가지입니다: 지침 책자 (18 페이지)

페이지 인쇄

132991190.qxd

17/09/2003

09:13

Installation

Unpacking

All transit bolts and packing must be removed

before using the appliance.

You are advised to keep all transit devices so that

they can be refitted if the machine ever has to be

transported again.

1. Using a spanner, unscrew and remove the rear

right-hand bolt and lay the machine on its back,

taking care not to squash the hoses. This can be

avoided by placing one of the corner packing

pieces between the machine and the floor.

2. Remove the polystyrene block from the underside

of the machine and release the two plastic bags.

3. Carefully remove the right-hand bag (1) then the

left-hand bag (2) by pulling them towards the

centre of the machine.

4. Unscrew and remove the feet.

5. Fit the grid (A) on the bottom of the machine

using the four screws (B) you will find in the bag

containing the instruction booklet.

Re-fit the feet.

6. Set the machine upright and remove the two

remaining bolts from the back.

Pagina

(Nero/Process Black pellicola)

7. Pull out the three plastic spacers from the holes

into which the bolts were fitted.

8. Plug the open holes with the plugs which are

supplied with the instruction book.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is

not impeded by carpets, rugs etc. Check that the

machine does not touch the wall or other kitchen

units.

Carefully level by screwing the adjustable feet in or

out. Never place cardboard, wood or similar

materials under the machine to compensate for any

unevenness in the floor.

Water inlet

Connect the water inlet hose supplied with the

appliance to a tap with a 3/4" thread.

Do not use already employed inlet hoses.

The other end of the inlet hose which connects to the

machine can be turned in any direction. Simply

loosen the fitting, rotate the hose and retighten the

fitting, making sure there are no water leaks.