Draytek VigorAP 800 사용자 설명서 - 페이지 6

{카테고리_이름} Draytek VigorAP 800에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draytek VigorAP 800 8 페이지. 802.11n access point

Installing Your Router

This section will guide you to install the AP through hardware connection

and configure the settings through web browser.

Before starting to configure the router, you have to connect your devices

correctly.

1. Connect VigorAP 800 to ADSL modem, router, or switch/hub in your

network through the LAN A port of the access point by Ethernet cable.

Note: You can also connect VigorAP 800 to a Vigor router via wireless

connection. For detailed information, refer to VigorAP 800 User's

Guide.

2. Connect a computer to other available LAN A port. Make sure the

subnet IP address of the PC is the same as VigorAP 800

e.g., 192.168.1.X.

3. Connect the A/C power adapter to the wall socket, and then connect it to

the PWR connector of the access point.

4. Power on VigorAP 800.

Check all LEDs on the front panel. ACT LED should be steadily on,

LAN LEDs should be on if the access point is correctly connected to the

ADSL modem, router or switch/hub.

management IP