Draytek VigorAP 903 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Draytek VigorAP 903에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draytek VigorAP 903 17 페이지. 802.11ac access point
Draytek VigorAP 903에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (16 페이지)

페이지 인쇄

Note

For safety reasons, keep the accessory kit away from small children

Interface

Description

Wireless band will be switched on/off in a cycle.

For example,

2.4G (On) and 5G (On) – Default state.



2.4G (Off) and 5G (On) – press and release the



button once.

2.4G (On) and 5G (Off) – press and release the



button twice.

2.4G (Off) and 5G (Off) – press and release the



button three times.

When WPS is enabled in the router's web

interface, press this button for more than 2 seconds

to enable WPS pairing mode

Restore the default settings. Usage: Turn on the

VigorAP (ACT LED is blinking). Press gently and

hold for more than 10 seconds. When the ACT

LED blinks rapidly, release the button and the AP

will restart with its factory default configuration

RJ-45 Gigabit Ethernet connector for local network

LAN B

devices. Separate from LAN-A when "Enable 2

Subnet (Simulate 2 APs)" is enabled

RJ-45 Gigabit Ethernet connectors for local

LAN A4,

network devices / uplink to router

A3, A2

LAN A1 is also used for powering the VigorAP via

A1 (PoE)

PoE connection (for indoor use)

Connector for the power adapter

Connecter for a USB device (for temperature

sensor)

Power switch.