Draytek VigorAP 910C 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} Draytek VigorAP 910C에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draytek VigorAP 910C 18 페이지. 802.11ac ceiling-mount access point
Draytek VigorAP 910C에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (19 페이지), 빠른 시작 매뉴얼 (16 페이지)

페이지 인쇄
Draytek VigorAP 910C 빠른 시작 매뉴얼
4
.
4
C
o
n
n
e
c
t
i
n
g
w
i
t
h
o
u
t
a
D
r
a
y
T
e
k
R
o
u
t
e
r
/
L
A
N
4
.
4
C
o
n
n
e
c
t
i
n
g
w
i
t
h
o
u
t
a
D
r
a
y
T
e
k
R
o
u
t
e
r
/
L
A
N
The Vigor AP-910C will attempt to get its IP address automatically from
your LAN's DHCP server (normally provided by your router).
Your router should have a diagnostic or other menu on its web interface
which allows you to find the VigorAP in its DHCP table.
Check that DHCP table to find an entry with a MAC address matching the
VigorAP – the VigorAP's MAC address is printed on a label on the base.
Once you have the VigorAP's IP address, you can access its own web
interface, as shown in section 4.6
You can connect the AP-910C directly to a PC with the Ethernet cable – i.e.
without any switch or router at all. You may wish to do this temporarily
just for configuration purposes, or if you intend using bridge mode.
If your VigorAP fails to get an IP address from a DHCP server on the LAN
(which would be the case if you connect directly to a PC), its IP address
defaults to 192.168.1.2 (subnet mask 255.255.255.0).
In order to access the VigorAP's web interface from a PC, that PC must have
an IP address within the same subnet. For example, 192.168.1.3 is in the
same subnet so you could manually set your PC to that temporarily in order
to access the VigorAP's web interface and set it up as needed.
Go to http://192.168.1.2 in your PC's browser and the VigorAP's login
prompt should appear. The default username and password is admin/admin –
which you should change. Remember that on a network with a DHCP server,
the VigorAP will get its IP address from that, so the VigorAP's IP address
won't be 192.168.1.2 (except by coincidence).