Dražice OKC 200 NTRR / BP 작동 및 설치 매뉴얼 - 페이지 12

{카테고리_이름} Dražice OKC 200 NTRR / BP에 대한 작동 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dražice OKC 200 NTRR / BP 20 페이지. Stationary water heaters
Dražice OKC 200 NTRR / BP에 대해서도 마찬가지입니다: 작동 및 설치 매뉴얼 (17 페이지), 작동 및 설치 매뉴얼 (12 페이지), 작동 및 설치 매뉴얼 (19 페이지), 작동 및 설치 매뉴얼 (20 페이지), 작동 및 설치 매뉴얼 (18 페이지), 운영 및 설치 매뉴얼 (20 페이지), 작동 및 설치 매뉴얼 (18 페이지), 운영 및 설치 매뉴얼 (13 페이지)

페이지 인쇄
Dražice OKC 200 NTRR / BP 작동 및 설치 매뉴얼

2.4 ELECTRIC WIRING

2.4.1 ELECTRIC INSTALLATION GENERAL INFORMATION

the electric wiring casing remove the partition corresponding with the input wire diameter of ∅8 or ∅10
Perform the connection according to the scheme. Factory connection must not be changed! (Figure 5) In
(Figure 4). The degree of protection of electric parts of the appliance is IP 45. Power input of electric
element is 4000 W.
Figure 4
It is necessary to observe the below requirements during the electric wiring:
•
The electric wiring scheme is attached to the appliance on the side of the electric
installation guard (Figure 5).
•
Connection, repairs, and wiring inspections may only be implemented by a company
(person) authorised to such activity.
•
Expert connection must be confirmed on the warranty certificate.
•
The appliance is connected to the 3/N/PE ~ 230V/50Hz electric network using a fixed
moving conductor with a switch that turns off all network poles and the circuit
breaker (protector).
•
Installations in bathrooms, lavatories and showers must comply with the standards.
•
The degree of protection of electric parts of the appliance is IP 45.
•
Respect the rules of protection against electrical injuries in accordance with
Standards.
Figure 5
- 12 -