Dražice OKC 200 SOL 작동 및 설치 매뉴얼 - 페이지 13

{카테고리_이름} Dražice OKC 200 SOL에 대한 작동 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dražice OKC 200 SOL 19 페이지. Water heaters for solar systems

2.2 EXAMPLES OF HEATERS CONNECTION

Heater shall be connected to a solar system by a person familiarised with these heating

systems. Temperatures in a solar circuit may achieve far over 100 °C, and there are

higher pressures than in typical heating systems, therefore correct selection if

interconnecting materials and its coupling is of great importance, as well as correct

dimensioning of the expansion tank connected to this system.

The heater is placed on the ground, next to the heating source, or in its vicinity. The heating circuit is

connected to marked inputs and outputs of the heater exchanger; the deaeration valve designed for solar

system is mounted in the highest place. It is recommended to flush the heating circuit before the assembly.

All wiring connections must be properly insulated from heat.

Connection of heater:

The manufacturer recommends mounting of a mixing valve on the hot water outlet, on

sunny days the temperature in the heater can achieve up to 90 °C which is a

temperature that, in case of scalding, may cause health complications. Output

temperature suitable for common use shall be set on the mixing valve.

Cold water shall be connected to an inlet marked with a blue ring or writing "HSW INLET". Hot water shall

be connected to an outlet marked with a red ring or writing "HSW INLET". If the hot service water (HSW)

distribution is equipped with circulation circuit, it shall be connected to the outlet marked with

"CIRCULATION". For potential drain of heater, the HSW inlet has to be provided with a "T" fixture with a

drain valve. Each individually lockable heater must be at the cold water inlet provided with a stop gate, test

cock, safety valve with a reverse flap and a pressure gauge.

- 13 -