Dražice OKC 200 SOL 작동 및 설치 매뉴얼 - 페이지 16

{카테고리_이름} Dražice OKC 200 SOL에 대한 작동 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dražice OKC 200 SOL 19 페이지. Water heaters for solar systems

2.4 PUTTING THE HEATER INTO OPERATION

PROCEDURE OF FIILING HEATER WITH WATER

1. Open the stop valve on the entry to the heater.

2. Open the hot water valve on the combination faucet. Once water starts flowing out through the

combination faucet the filling is completed and the faucet shuts off.

3. Check the joints for tightness.

4. When commencing operation, flush the heater until the cloudiness in the water is gone.

5. Make sure to fill in properly the warranty certificate.

If water contains too many minerals, an expert has to come to remove the scale that forms

inside the tank, as well as free sediments. This has to be performed after one or two years of

operation. The cleaning is carried out through the hole in the flange – dismantle the flange lid

and clean the tank. A new sealing has to be used for re-fitting. Since the inside of the heater

has special enamel, which must not get in contact with the scale removing agent – do not

work with a lime pump. Remove the lime layer with a timber and suck it off, or wipe it off

with a clout. After that, the appliance must be rinsed thoroughly and the heating process is

checked the same as during the initial putting in operation. Do not use any abrasive cleaning

agents (such as liquid sand, chemicals – acid, alkaline) or dye thinners (such as cellulose

thinner, trichlor, and the like) to clean the outer shell of the heater. For cleaning use a wet

clout and add a few drops of liquid cleaning agent for household applications. Repetitive

water heating causes limestone sediment on both the tank walls and chiefly the flange lid.

The sedimentation depends on the hardness of water heated, its temperature, and amount

of hot water consumed.

We recommend checking and cleaning the tank from scale and eventual replacement of the

anode rod after two years of operation. The anode life is theoretically calculated for two

years of operation; however, it changes with water hardness and chemical composition in the

place of use. Based on such an inspection, the next term of anode rod exchange may be

determined. If the anode is only blocked with sediments clean its surface and, if used up,

mount a new one. Have the company in charge of service affairs clean and exchange the

anode. When draining water from the heater, the combination faucet valve for hot water

must be open, preventing occurrence of under-pressure in the heater tank which would stop

water from draining.

ANODE ROD EXCHANGE METHOD

1. Turn off the boiler control voltage.

2. Drain about 1/5 of the volume of water from the heater.

PROCEDURE:

3. The anode is screwed in under the plastic guard in the top lid of the heater.

4. Unscrew the anode using adequate wrench.

5. Pull the anode out and follow reversed steps to install a new one.

6. During the assembly, make sure the ground wire is connected properly; it is essential for proper

anode function.

7. Fill the boiler with water.

Close the water entry valve to the boiler.

Open the hot water valve on the combination faucet.

Open the boiler drain tap.

- 16 -