Advanced ICE 1324-1 설치 지침 - 페이지 3

{카테고리_이름} Advanced ICE 1324-1에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Advanced ICE 1324-1 4 페이지. Jeep/dodge caravan camera integration

Mode Change and Operation

Tip: you can press and hold the icon on and drag to the bottom screen panel - this

Installation Guide

y Gain access to the back of the monitor.

y Unplug the quad lock connector from the factory monitor and insert provided Plug and Play Quad Lock T Harness.

y In the Plug and Play Harness, there are two yellow RCA connectors joined together. Disconnect these and do

the following:-

h Connect the female RCA from the vehicle side of the harness to the Male Video Output of VSW Video

Switch

h Connect the male RCA from the vehicle side of the harness to the VSW Video 1 Input

h The Blue/White Trigger wire is not used for this installation and should be isolated.

h Connect the Black wire of the VSW to ground along with the Black wire from the V2P-II Interface

y Connect the White/Red Video 2 Trigger of the VSW to the Red Switched Power wire Output of the V2P-II

Interface. When a video signal is present on the RCA this wire will output 12v.

y Connect the Yellow 12v (+) of the V2P-II to ACC or Ignition.

y Connect the RCA Video Output of the V2P-II to the Video 2 Input of the VSW Video Switch.

y Connect the RCA Video cable from the caravan camera to the video female input of the V2P-II

To activate the front camera while driving forward simply double tap REAR Defrost Button on the radio.

Please refer to the wiring diagram on the next page (Figure 6) for more information.

Press the Back CAM icon to activate the camera while driving forwards

keeps the camera button accessible at all times.

Fig. 7