Alen Paralda 사용자 설명서 - 페이지 6

{카테고리_이름} Alen Paralda에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alen Paralda 9 페이지. Hepa air purifier
Alen Paralda에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용자 설명서 (7 페이지), 사용자 설명서 (12 페이지), 사용자 설명서 (10 페이지)

페이지 인쇄

How to Replace the filter

Lift the filter cover.

Turn the plastic locking mechanism that holds the

filter in place to unlock the filter.

Lift straight up on the filter cartridge handle and

remove completely.

Insert the new filter.

Lock the new filter in place.

Reset the filter replacement indicator – when the

cover is open, using the tip of a pen, press and

hold the pen in the Filter Reset button for three

seconds.

PRogRAMMINg ThE PARALdA

The Paralda can be programmed to run at certain fan speeds at three pre-set times through-

out the day. This is done in the program mode. When in the Program Mode, one of the three

settings directly below the clock will be illuminated (1, 2, or 3). When in Manual Mode, the set-

tings are not illuminated and the air purifier will operate continuously at the current fan speed.

This is your visual indication for which mode you are using. When first turned on the air purifier

will be in manual mode. To change back to Manual Mode from Program Mode simply press

the unit off and turn back on.

To Program Your Paralda

Press and hold PGM key for two seconds to enter the setup mode. The unit will beep and

the clock with then blink. The current time will turn on.

Press +/- to change the time.

Press the PGM key to accept the current time. The current time turns off and the setting

1 icon turns on. The clock will start blinking.

Press +/- to change the time for setting 1.

Press the PGM key to accept the time for setting 1.

Press the SPEED button to select the fan speed for setting 1. This is the speed you want

the fan to run for the first preset time of the day.

Press the PGM key to accept the fan speed for setting 1.