Drazice Okce 125 운영 및 설치 매뉴얼 - 페이지 15
{카테고리_이름} Drazice Okce 125에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drazice Okce 125 16 페이지. Tank-type water heater for vertical
mounting
Drazice Okce 125에 대해서도 마찬가지입니다: 작동 및 설치 매뉴얼 (18 페이지), 운영 및 설치 매뉴얼 (19 페이지)
페이지 인쇄
4 IMPORTANT NOTICES
4.1 INSTALLATION REGULATIONS
Without a proof issued by a professional company about performed electrical and plumbing
fixture the warranty shall be void.
It is necessary to check the protective magnesium anode periodically and replace it if
necessary.
No closing armature may be mounted between the tank and the safety valve.
If the overpressure in the eater main exceeds 0.48 MPa, a reduction valve must be mounted
before the safety valve.
All outlets of hot water must be equipped with combination faucets.
Before the first filling of water heater it is recommended to tighten the nuts of the flange
joint of the tank.
It is not allowed to handle the thermostat, aside from temperature resetting with a control
button.
All electric installation handling, setting, and regulation feature exchange, may only be
implemented by a service company.
The thermal fuse must not be turned off! In case of a thermostat defect, the thermal fuse
interrupts electric power supply to the heating element if the water temperature in the
heater exceeds 95°C.
As an exception, the thermal fuse may also switch off due to water overheating caused by
overheating the hot water heating system boiler (in case of a combined heater).
We recommend that the tank is only operated on one energy source.
Both the electric and water installation must follow and meet the requirements and
regulations relevant in the country of use!
- 15 -