Drazice OKC 160 NTR / BP 운영 및 설치 매뉴얼 - 페이지 12
{카테고리_이름} Drazice OKC 160 NTR / BP에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drazice OKC 160 NTR / BP 20 페이지. Stationary water heaters
Drazice OKC 160 NTR / BP에 대해서도 마찬가지입니다: 작동 및 설치 매뉴얼 (17 페이지), 작동 및 설치 매뉴얼 (12 페이지), 작동 및 설치 매뉴얼 (20 페이지), 작동 및 설치 매뉴얼 (20 페이지), 작동 및 설치 매뉴얼 (18 페이지), 작동 및 설치 매뉴얼 (18 페이지), 운영 및 설치 매뉴얼 (13 페이지)
페이지 인쇄
2.4 ELECTRICAL INSTALLATION
2.4.1 GENERAL INFORMATION FOR ELECTRICAL INSTALLATION
Perform the connection according to the scheme. Factory connection must not be changed! (Obrázek 5). In
the electric wiring casing remove the partition corresponding with the input wire diameter of φ8 or φ10
(Figure 4).The degree of protection of electric parts of the heater is IP 44. Power input of electric element is
2000 W.
It is necessary to observe the below requirements during the electric wiring.
•
The wiring diagram is attached to the heater on the side of the electric installation
guard (see Fig. 5).
•
Connection, repairs, and wiring inspections may only be implemented by a company
(person) authorised to such activity.
•
Expert connection must be confirmed on the warranty certificate.
•
The heater is connected to the 230 V/50 Hz electrical network using a fixed moving
conductor with a switch that turns off all network poles and the circuit breaker
(protector).
•
Installations in bathrooms, laundry rooms, rest rooms and showers, must be in
compliance with standard.
•
The degree of protection of electric parts of the heater is IP 44.
•
Adhere to the protection against electric shock injury according to standard.
Figure 4
Figure 5
- 12 -