Drazice OKCE 160 NTR 운영 및 설치 매뉴얼 - 페이지 9

{카테고리_이름} Drazice OKCE 160 NTR에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drazice OKCE 160 NTR 19 페이지. Tank-type water heater for vertical mounting
Drazice OKCE 160 NTR에 대해서도 마찬가지입니다: 작동 및 설치 매뉴얼 (18 페이지), 운영 및 설치 매뉴얼 (13 페이지)

페이지 인쇄

2 OPERATION AND FITTING INSTRUCTIONS

2.1 OPERATING CONDITIONS

The tank shall only be used in accordance with the conditions specified on the power plate

and in instructions for electric wiring. Besides legally acknowledged national regulations

and standards, also conditions for connection defined in local electric and water works have

to be adhered to, as well as the installation and operation manual.

The temperature at the place of heater installation must be higher than +2°C; and the room

must not freeze. The appliance has to be mounted at a convenient place, it means

that the appliance must be easily available for potential necessary maintenance, repair

or replacement, as the case may be.

If water is strongly calcareous we recommend that any of the common decalcifying devices

was installed with the appliance, or that the thermostat was set to the minimum operating

temperature of 60

operation, drinkable water of adequate quality shall be used. To avoid potential sediments we

recommend that the device was installed together with a water filter.

2.2 WALL MOUNTING

Prior to the mounting check the bearing capacity of the wall and the material it is made

of, considering the weight of the heater filled with water. Depending on the wall material choose

adequate fixtures. Should you have any doubts regarding the wall bearing capacity, consult

the suspension with a building specialist. The minimum diameter of the bolts for suspending

the heater is 12 mm. When mounting the anchor bolts follow the guide provided by the anchor

bolts' manufacturer.

Mount the anchors by the dimensional drawing (Figure 2, Figure 3) in 450 mm spacing. The heater verticality

after the release of the connecting screws can be aligned by means of slight turning. Double check the torque

of the suspension bolts on the heater and suspend the heater. Using the detent support in the bottom part

of the heater make sure it runs in parallel with the wall at the heaters OKHE 80-160 l!

C (setting to position „ECO" or „OPTIMUM") - Figure 12, Figure 13. For proper

Figure 4

- 9 -