Bosch VGD553FR0 사용 설명서 - 페이지 17
{카테고리_이름} Bosch VGD553FR0에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch VGD553FR0 44 페이지. Built-in oven
Lock the two hinges on the left and right using the
2.
locking pin (a).
The locking pins must be fully inserted into the
Note:
holes in the hinges.
Take hold of the sides of the oven door with both
3.
hands and close the oven door by approx. 30° (b).
Lift the oven door slightly and pull it out.
4.
Do not close the oven door fully,otherwise the
Note:
hinges could become bent and the enamel could be
damaged.
Fitting the appliance door
Take hold of the sides of the oven door with both
1.
hands.
Slide the hinges into the slots in the oven (a).
2.
The notch at the bottom of the hinges must
Note:
engage into the frame of the oven (b).
T r o u b l e s h o o t i n g
Fault
The appliance is not working
The oven lighting has failed.
All food that is cooked in the oven
burns within an extremely short
period of time.
The flame (oven) does not burn
through all outlet openings.
Door panels are steamed up.
--------
Replacing the oven light bulb
If the oven light bulb fails, it must be replaced.
Replacement heat-resistant bulbs can be obtained from
the after-sales service or from specialist retailers.
Please specify the E number and FD number of your
appliance. Do not use any other type of bulb.
:
Warning – Risk of electric shock!
When replacing the cooking compartment bulb, the
bulb socket contacts are live. Before replacing the bulb,
unplug the appliance from the mains or switch off the
circuit breaker in the fuse box.
Allow the cooking compartment to cool down.
1.
Possible cause
The plug is not plugged into the mains
Power failure
The circuit breaker is faulty
Safety switch-off function
Oven light is faulty
Thermostat faulty.
Normal build-up of dirt
This is normal and results from differences in temper-
ature.
Lower the door.
3.
Remove the locking pins.
4.
:
Warning – Risk of injury!
If the oven door falls out accidentally or a hinge snaps
shut, do not reach into the hinge. Call the after-sales
service.
:
Warning – Risk of injury!
The door may not close properly if the door hinges have
not engaged correctly. This will allow heat to escape
and the parts of the appliance may become very hot. To
prevent this from happening, remove the door again.
Then refit the door as shown in the drawing, making
sure that the groove on the underside of the hinges
engages in the oven frame.
Information/remedy
Connect the appliance to the mains electricity supply
Check whether other kitchen appliances are working
Check in the fuse box to make sure that the circuit
breaker for the appliance is in working order
Allow the appliance to cool down, check the gas sup-
ply
Replace the oven light. (See section "Replacing oven
light")
Call the after-sales service.
The burner must be professionally cleaned.
Heat the appliance up to 100 °C and then switch it
back off after 5 minutes.
Open the appliance door.
2.
Place a tea towel in the cooking compartment to
3.
prevent damage.
Remove the shelf supports.
4.
Remove the glass cover.To do this, open the glass
5.
cover from the front with your hand. Should you
experience difficulties removing the glass cover, use
a spoon to help you.
Remove the oven light bulb.
6.
Trouble shooting
en
17