Bosch Vision 800 Series 서비스 매뉴얼 - 페이지 15
{카테고리_이름} Bosch Vision 800 Series에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Vision 800 Series 43 페이지. Gas slide-in ranges
Bosch Vision 800 Series에 대해서도 마찬가지입니다: 사용 설명서 지침 (40 페이지), 치수 및 사양 (2 페이지), 설치 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (28 페이지), 서비스 매뉴얼 (36 페이지)
페이지 인쇄
58300000202443_ARA_EN_C
To remove the Solo microwave or Speed microwave oven...
1. Remove power to the oven.
2. Remove the screws securing the right and left side trim pieces
to the cabinetry.
3. Carefully slide the combination unit completely out of the
cabinet cutout.
4. Proceed to step 6 if servicing a Speed microwave oven
5. Unplug the power cord from the receptacle if servicing a Solo
microwave then proceed to step 7.
NOTICE
The 120VAC receptacle snaps into the rear housing cover.
Gain access to the receptacle's electrical fuse and wiring termination
by removing the top front cover.
Figure 8 120VAC receptacle and harness (HBL87M52UCC only)
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JANUARY 2018
6. Disconnect the feeder wires from the terminal block (see
Figure 7): only necessary if a work table is not nearby, and the
5' length of conduit/wire will not be sufficient.
7. Remove the front decorative trim that is secured to the
universal brackets with two screws.
8. Remove the six screws which secure the microwave to the
right and left universal brackets
Speed or Solo MW oven
Figure 9 Removing screws securing microwave to universal brackets on top of wall oven.
9. Carefully lift the microwave off the universal brackets, and set
aside.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Built-in Wall Ovens
Universal Brackets
Wall Oven
Page 15 of 43
800 944-2904