Bosch Vision 800 Series 서비스 매뉴얼 - 페이지 26
{카테고리_이름} Bosch Vision 800 Series에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Vision 800 Series 36 페이지. Gas slide-in ranges
Bosch Vision 800 Series에 대해서도 마찬가지입니다: 사용 설명서 지침 (40 페이지), 치수 및 사양 (2 페이지), 설치 매뉴얼 (6 페이지), 서비스 매뉴얼 (43 페이지), 설치 지침 매뉴얼 (28 페이지)
페이지 인쇄
58300000194725 ARA EN B
8. Secure the new fan to the fan mounting bracket, attach the
wires and reassemble.
9. Restore power to the unit and test operation.
10. Reinstall housing cover(s).
11. Slide the range back into the cutout.
6.10
Hinge Receivers
To replace the hinge receivers, the range must be pulled out of
the cutout to provide access to the side panel(s).
6.10.1 Replacing the Hinge Receivers
1. Remove power to the range.
2. Remove the oven door (see Removing and Reinstalling the
Door).
3. Carefully slide the range out of the cutout to gain access to the
side panels.
4. Remove the finished side wall panel.
5. Remove the inner side wall bracket.
6. Remove the side housing cover.
7. From the front of the range, remove the two screws securing
the hinge receiver to the range.
8. Pull back the side insulation to reveal the hinge receiver and
remove the part.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2016
Figure 35 Removing the RH hinge receiver
9. Install the new hinge receiver.
10. Reinstall the oven door and test door operation.
11. Reinstall the side housing cover, the side wall bracket and the
finished side wall panel.
12. Slide the range back into the cutout, restore power, and test
operation.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Gas Slide-in Ranges
Page 26 of 36
800 944-2904