Anchor AN-130 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Anchor AN-130에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor AN-130 8 페이지. Portable public address sound system
Anchor AN-130에 대해서도 마찬가지입니다: 사양 (1 페이지), 브로셔 및 사양 (2 페이지), 카탈로그 (2 페이지), 소유자 매뉴얼 (4 페이지)

페이지 인쇄

Replacing Transmitter Battery

CAUTION:

Handheld Transmitter:

Harmful

1. Unscrew battery compartment cover on lower end of mic.

feedback may

occur when

2. Install 2 fresh 'AA' alkaline batteries.

walking in

3. Replace the battery cover.

front of a

sound system

or speaker

with a

wireless

microphone.

Always point

mic away

from speakers.

Body-pack Transmitter:

1. Slide open battery cover on front of transmitter box.

2. Install 2 fresh 'AA' alkaline batteries.

NOTE:

3. Close the battery cover.

Transmitter

power switch

must be in the

OFF position

when

changing

batteries.

WIRELESS OPERATION

Place batteries into slot

and slide forward

GENERAL OPERATION

Line Inputs (summing)

The line-level RCA input jacks may be used with audio sources such

as computers, VCR's, and cassette tape or compact disc players.

The inputs may be used for two separate sources, or they may be

used to sum L+R stereo outputs to a mono signal without the need

for adapters.

Mic Input

An unbalanced, low impedance microphone input is for use with the

MIC-90P or other mics that have a 1/4" phone plug.

Instrument Input

The instrument input (1/4"-phone jack) is for guitars, keyboards or

any instrument with an electronic transducer. It may also be used for

wireless microphone receivers. The instrument input has a higher

sensitivity than the line input.

Note: All connections must be made with shielded cable to avoid

hum, buzzing, or radio interference.

DC Output (AN-130DC model only)

12 Volts DC output jack for use with wireless or other external

accessories; maximum capacity of 100 mA max.