Anchor AN-130U1+ 소유자 매뉴얼 - 페이지 2

{카테고리_이름} Anchor AN-130U1+에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor AN-130U1+ 7 페이지.
Anchor AN-130U1+에 대해서도 마찬가지입니다: 소유자 매뉴얼 (6 페이지)

AN-130+ Speaker Monitor Owners Manual

BASIC SYSTEM OPERATION

The AN-130+ monitor is used to amplify the signal

from a microphone, electronic musical instrument or

line-level sources (MP3, cassette, CD, VCR, etc).

You'll need a connection cable and an AC outlet.

1. Place the AN-130+ in desired location

2. Set volume control on front of speaker to

minimum

3. Plug the power cord into a grounded 115 volt

outlet

(220 volt outlet for export model)

4. Plug a microphone into the MIC input jack, or an

audio source into a LINE IN jack

5. Turn the power switch on the rear panel "ON"

(red LED on front panel should light)

6. Adjust the volume, bass & treble controls to

desired levels

IMPORTANT: To avoid feedback, do not position

a microphone in front of speaker.

LINE IN

The line-level input jacks may be used with audio sources such as computers,

VCR's, or portable audio players.

MIC IN

An unbalanced, low impedance

microphone input is for use with the

MIC-90P or other mics that have a 1/4"

phone plug.

BACK PANEL OF AN-130U1+

LINE OUT

The unbalanced Line-out provides a combined signal of all inputs being used.

You can use this function to record your presentation or to "daisy chain" another

powered sound system to the AN-130+ for greater crowd coverage.

Note: This output is post source level; any volume fluctuations for a specific input

will affect the output signal level at this output.

MADE IN USA

SIX YEAR WARRANTY

POWER SWITCH

POWER CORD

NOTE: SEE PAGE 4

FOR WIRELESS RECEIVER

INSTRUCTIONS