FORM FIT HD 5G 11 빠른 시작 매뉴얼

{카테고리_이름} FORM FIT HD 5G 11에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FORM FIT HD 5G 11 2 페이지. Hood protector for chevrolet cruze 2011-

페이지 인쇄

FORM FIT

Chevrolet Cruze 2011

Hardware Kit

4 – Large Bumpons

4 – 3M Anti-Abrasion Film Pad

4 – Clip Bodies

4 – Pins

4 – 'L' Brackets

4 – #6 x 5/8" Flat Head Screws

*Note: This Part has 2 Supporting Clips, 2 Pins, and 2 Push Nuts – already installed on the protector.

Installation

Be sure that the hood is clean and dry inside and out. Release the hood, but do not open it.

Install the four (4) bumpons on the hood as shown in illustration #1. Attention: The bumpons must be installed on the hood not the

protector!!! If the bumpons are installed on the protector, they will wear through the paint.

Center the protector on the hood by using the body lines shown in illustration #1.

Work from left to right pushing each of the protector supporting clips (already attached to protector) over the edge of the hood. Be sure the

protector clips are fully seated against the hood edge.

With protector centered on the hood, peel and fold an anti-abrasion film pad in half over the edge of the hood, underneath each of the four (4)

holes in the protector. See Illustration #2 – Step #4.

6a) Place a clip over each of the anti-abrasion film pads on the edge of the hood as shown in Illustration #2 – Step #5a.

b) Insert a pin through the protector into each of the clips. See Illustration #2 – Step #6b.

c) Insert a #6 x 5/8'' screw through an 'L'- bracket and into the clip. See Illustration #2 – Step #6c & 6d.

d) Make sure all the components are well seated together; the protector is centered on the hood, and then tighten the screws into the clips.

Repeat step #5 and #6 for the outer two (2) holes.

On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.

Note: Do not pull on the protector when opening or closing the hood.

Care Instruction

Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents. Periodically check

to make sure that the hardware is in place and that the protector is secure. Avoid using automatic car washes. Do not pull on the protector

when opening or closing the hood.

Illustration #1: Bumpon Location and Body Line Reference

Illustration #2: Clip Configuration

Step #5

Thank you for purchasing a form fit hood protector. Retain this sheet for care instructions and kit information.

Made in Canada

HOOD PROTECTOR

–

- Patent No. 6,892,427

Step #6a

Tools Required

1 – Phillips Screwdriver #2

1 – Tape Measure

1 – Grease Pencil

Step #6b

HD 5G 11

Step #6c & 6d

Rev0.110412