Anchor megavox 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Anchor megavox에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor megavox 2 페이지. Portable
Anchor megavox에 대해서도 마찬가지입니다: 소유자 매뉴얼 (7 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

CONNECTING ANCHOR AIR WIRELESS

COMPANION SPEAKER

1. Connect provided external antennas to main unit and AIR companion unit.

2. Power on main unit and AIR companion.

3. Verify the AIR companion speaker is in AIR MODE by checking the AIR/WIRED toggle switch.

4. On main unit, push AIR Companion Transmitter POWER button to turn on AIR transmitter. On AIR

companion, push AIR Companion Receiver POWER button to turn on AIR receiver.

5. Adjust volume knob on back panel as needed.

NOTE: Verify both AIR Companion Transmitter and AIR Companion Receiver are synchronized to the same

channel. The default frequency setting is 902.00. This can be changed as needed.

CHANGING FREQUENCIES ON THE AIR COMPANION

1. Using a pointed edge tool, hold SET button for 2 seconds. Digital display will blink.

2. Press UP or DOWN to select desired frequency.

3. To confirm frequency selection, press SET button or wait 10 seconds for display to stop blinking.

ANCHOR AIR SYSTEM ARRANGEMENT

MICROPHONE

150 FEET MAX

300+ FEET

ANCHOR AIR: USEFUL INFORMATION

• Main unit must have built-in AIR Companion Transmitter (X-series)

• Main unit can connect to an unlimited number of AIR Receiver Companion speakers (AIR & R-series)

• AIR companion speaker can be placed 300+ ft. from the main unit

• Although AIR has volume control, the main unit volume will raise or lower AIR companion volume

• AIR Transmitter connects to Anchor Audio Assistive Listening belt pack receivers

CONNECTING AIR TRANSMITTER TO ASSISTIVE

LISTENING BELT PACK RECEIVERS

1. Follow instructions to set up AIR Companion Transmitter

2. Install two AA 1.5V batteries in Assistive Listening belt pack (ALB-9000)

3. Straighten belt pack antennas for maximum reception

4. Plug in headphones to belt pack

5. Power on belt pack and adjust volume as needed.

NOTE: Verify both AIR Companion Transmitter and ALB-9000 are synchronized to the same channel. The

default frequency setting is 902.00. This can be changed as needed. Follow instructions above in Changing

Frequencies.

CONNECTING AIR COMPANION SPEAKER - WIRED

1. Power off main unit and AIR companion speaker.

2. On the AIR companion speaker, move toggle switch to WIRED MODE.

3. Follow instructions below to connect speakers using a wired connection.

AIR COMPANION

Connect speaker cable (SC-50NL) to the SPEAKER OUT jack on the back of the

powered Liberty or Go Getter sound system. Connect the other end of the jack

to the back of an unpowered companion speaker. AC power is not required for an

LIBERTY &

unpowered companion speaker. The AIR companion can be operated on battery

GO GETTER

power or AC power.

Connect speaker cable (SC-50) to the SPEAKER OUT jack on the back of a powered

MegaVox PA system. Connect the other end of the jack to the back of an unpowered

MEGAVOX

companion speaker. The AIR companion can be operated on battery power or AC power.