Bosch 1617EVSPK 작동/안전 지침 매뉴얼 - 페이지 12

{카테고리_이름} Bosch 1617EVSPK에 대한 작동/안전 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 1617EVSPK 24 페이지. Router tools
Bosch 1617EVSPK에 대해서도 마찬가지입니다: 사용자 설명서 (34 페이지)

페이지 인쇄

BM 2610018532 01-12:BM 2610018532 01-12.qxp 1/23/12 9:21 AM Page 12

CHIP DEFLECTOR

Always

WARNING

protection.

deflector is not intended as a safety guard.

The chip deflectors help keep dust and chips

out of your face, it will not stop objects larger

than dust thrown from the bit.

To remove chip shield from bases, press

inward on tabs until it releases from base and

remove. To attach, place deflector into position

as shown in (Fig. 9). Then flex sides of

deflector while pushing until it snaps into place.

The plunge base's chip shield can also be

flipped out.

FINE ADJUSTMENT DIAL

INDICATOR RING

CAST INDICATOR MARKS

COARSE

ADJUSTMENT

LEVER

Bosch routers are designed for speed,

accuracy and con venience in performing

cabinet work, routing, fluting, beading, cove-

cutting, dove tails, etc. They will enable you to

accomplish inlay work, decorative edges and

many types of special carving.

DEPTH ADJUSTMENT

WITH FIXED BASE

Router's RA1161 fixed base are equipped with

a true micrometer type fine adjustment

mechanism, which can be used in any position

and provides precise adjustment of the router

bit position for unmatched accuracy. When the

tool is lowered to the approximate position

desired, this device may be adjusted to

precisely set the final bit position.

wear

eye

The

chip

FIG. 9

Operating Instructions

Your router also features three horizontal

notches on both sides of the motor housing for

coarse adjustments. The notches are spaced

1/2" apart which allows you to quickly lower or

raise the tool depth in three 1/2" increments.

(Approximately 12.7 mm), by simply

depressing the coarse adjustment release

lever.

NOTE: All depth adjustments must be made

with the base clamp lever released.

1. Hold the tool in a horizontal position with the

2. Open the base clamp lever to release the

-12-

BASE CLAMP LEVER

TO ADJUST DEPTH

base clamp lever facing you.

motor.

FIG. 10