Dream Catcher ME3000 Analog Electronics Lab 6 매뉴얼 - 페이지 7

{카테고리_이름} Dream Catcher ME3000 Analog Electronics Lab 6에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dream Catcher ME3000 Analog Electronics Lab 6 19 페이지. Rf class a tuned amplifiers

페이지 인쇄

______________________________________________________________________

Appendix: Tips on Using Agilent E3631A Triple

Output DC Power Supply

Supplying +5 V, +15 V, and 15 V to the ME3000-M1 training kit:



Press Power to turn on the E3631A.

The E3631A has three adjustable output supplies namely +6 V, +25 V, and 25 V. By default,

all outputs are disabled (the OFF annunciator is turned on), the +6 V supply is selected, and

the knob is ready for voltage control.



Adjust the knob



Press Display Limit and set the current limit to 0.5 A.



Next, set the supply to +25 V (positive supply). Set the voltage to +15 V and current limit to

0.5 A. Repeat the same procedure for –25 V (negative supply) to set the voltage to 15 V and

current limit to 0.5 A.



Connect the E3631A to the ME3000 training kit as shown below.



Enable the power supply outputs by pressing Output On/Off. The CV and +25 V

annunciators should turn on.



Caution: If the CC annunciator is turned on, disable the output and check whether this is due

to the current limit setting or faulty connection.



Upon completion of each experiment and before making any connection on the training kit,

ensure that the power supply output is disabled by pressing Output On/Off.

ME3000 Analog Electronics

to +5 V.

4-way

connector

http://dreamcatcher.asia/cw

Power Supply

(E3631A)

25 V

6 V

com

–

ME3000-M1 Training Kit

–

Lab 6 - 7/19