Anchor Navi-Trac 사용자 설명서 - 페이지 11

{카테고리_이름} Anchor Navi-Trac에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor Navi-Trac 18 페이지. Tent jack
Anchor Navi-Trac에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 조립 지침 (3 페이지)

페이지 인쇄

LIFTING TOP FRAME

(FIRST SIDE)

UPRIGHT BRACES

LIFT TOP FRAME (SECOND SIDE)

1. LIFT 2ND SIDE OF FRAME TO INSTALL OPPOSITE SIDE CORNER

AND INTERMEDIATE UPRIGHTS.

2. INSTALL UPRIGHT BRACES AT ALL INTERMEDIATE UPRIGHTS.

FABRIC NOT SHOWN

FABRIC LIES LOOSELY ON FRAME UNTIL

UPRIGHTS ARE INSTALLED AND STAKED

INSTALL UPRIGHTS. AT INTERMEDIATE

LOCATIONS, INSTALL UPRIGHT BRACES

AS WELL

USING HEAVY-DUTY NAVI=TRAC FRAME

LIFTS, LIFT ONE SIDE OF FRAME. SLIDE

UPRIGHTS ONTO BOTTOM OF WELD-

MENTS ON THE RAISED SIDE AND PIN.

BE SURE ALL RAFTER AND HIP PINS ARE

SECURE, AS WELL.

INSERT BASEPLATES INTO UPRIGHTS AND

BOLT. NOTE: SQUARE FRAMES AND END

MODULE FRAMES MUST USE FIXED BASE-

PLATES. HINGED PLATES ARE TO BE USED

ONLY ON PIVOTING MIDDLE BEAMS FROM

THE EXTENSION FRAME SETS.

NOTE: BEFORE TENSIONING FABRIC, INSPECT

THE FRAME TO ENSURE INTERMEDIATE

RAFTER, BRACE AND HIP PINS ARE PROPERLY

SEATED IN THE WELDMENT FITTINGS AND

SECURED BY LANYARD PINS.

10-T

10-B