Anchor Navi-Trac 사용자 설명서 - 페이지 3
{카테고리_이름} Anchor Navi-Trac에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor Navi-Trac 18 페이지. Tent jack
Anchor Navi-Trac에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 조립 지침 (3 페이지)
페이지 인쇄SQUARING THE TENT FOOTPRINT LAYOUT
LOCATING
THE FOUR
PRIMARY
CORNERS
DIRECTIONS FOR SQUARING THE TENT
1. USE A TAPE MEASURE TO MARK THE ENDS OF A LINE FOR ONE END (A TO B ABOVE)
EQUAL TO THE EXACT WIDTH OF THE UNIT.
2. HOLD THE "0" END OF ONE TAPE AT POINT "A" AND THE "0" END OF ANOTHER TAPE
AT POINT "B".
3. EXTEND THE FIRST TAPE ALONG ONE SIDE OF THE UNIT TO A MEASUREMENT
EQUAL TO THE EXACT LENGTH OF THE TENT.
4. CONSULT THE CHART BELOW TO FIND THE DIAGONAL FOR THE TENT YOU ARE
BUILDING.
5. EXTEND THE SECOND TAPE TO A MEASUREMENT EXACTLY EQUAL TO THIS DIAGONAL.
6. BRING THE TWO TAPES TOGETHER SO THAT THE LENGTH MEASUREMENT OF ONE LIES
DIRECTLY ON THE DIAGONAL MEASUREMENT OF THE OTHER. PULL THE TAPES TIGHT
AND MARK THEIR INTERSECTION. THIS WILL LOCATE A FAR CORNER (POINT "D" ABOVE).
7. SWITCH TAPES SO THAT TAPE 1 (ABOVE) MEASURES THE DIAGONAL AND TAPE 2 (ABOVE)
MEASURES THE LENGTH. THIS WILL LOCATE POINT "C" ABOVE.
8. WITH THE FOUR PRIMARY CORNERS LOCATED, LAY OUT BASEPLATES AND UPRIGHTS
ACCORDING TO THE DIAGRAM TO THE RIGHT AND BEGIN ASSEMBLY, DOUBLE-CHECKING
FROM TIME TO TIME TO MAKE SURE THE SQUARE FOOTPRINT IS BEING MAINTAINED.
DIAGONALS FOR SQUARING FOOTPRINT
2
A
LENGTH OF TENT
B
LENGTH OF TENT
DIAGONAL SHOWN IN FEET-INCHES (TO NEAREST INCH)
BASEPLATE
END
INTERMEDIATE
UPRIGHT
D
C
SIDE
INTERMEDIATE
UPRIGHT
C/L
OUTER DIMENSIONS ARE
OUTSIDE-TO-OUTSIDE
C/L
INTERMEDIATE DIMENSIONS
ARE CENTER-TO-CENTER