Anchor VMS 25x32 조립 지침 매뉴얼 - 페이지 13

{카테고리_이름} Anchor VMS 25x32에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor VMS 25x32 16 페이지. Vehicle maintenance shelter 25' x 32' with extension kits

페이지 인쇄

STEP 10 - Pull second mid panel into place.

•

Proceed as with the first mid.

STEP 11 - Pull first gable end into place

• Be certain that the zippers of the Gable End are unzipped for ease of installation.

• Lay out one half of gable end panel at bottom of the appropriate end leg. White side of gable end to inside of tent and lace

edge goes in first. See figures 11a and 11b.

• Insert lace edge end of kedar into slotted opening of top/outer channel of lower leg. Push the inserted kedar up the channel

of the leg as far as possible (to about the corner). The zipper tool will be required to push the kedar up past the corner.

• Once the kedar is past the corner, the zipper tool may be used to guide the pull rope while another person pulls on the rope

until the lace edge of the gable end reaches the peak point of the frame. See figure 11a.

• Disconnect the pull rope.

• Repeat this process for the other side of the gable end.

• Go back to the slots where you started gable end installations, and stuff the remaining kedar into the lower channels below

the slotted openings down to bottom of leg.

• Join the two halves of the gable end at top and bottom with the carabiners attached to the top and bottom rings on the loop

side.

• Using a ladder, start lacing at the top of the gable and continue lacing until you reach the bottom loop. Tie off bottom loop.

As you are lacing, cover lacing with the protective flap and velcro closed.

• Gable end may be staked with stakes provided.

Pull rope

Your Vehicle Maintenance Shelter is now ready for use.

Zipper

Tool

Slotted

Opening

Gable end

Pull rope snapped onto

ring of Gable end.

Lace Edge

Slotted

Opening

Kedar of

Gable end

Figure 11a

Lower

Leg.

Slotted

Opening

Figure 11b