Anchor Cinemark Acclaim Lectern Sound System 소유자 매뉴얼 - 페이지 2
{카테고리_이름} Anchor Cinemark Acclaim Lectern Sound System에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor Cinemark Acclaim Lectern Sound System 8 페이지.
페이지 인쇄Cinemark Acclaim Lectern Sound System Owners Manual
BASIC SYSTEM OPERATION
NOTE: Fully Charge Batteries Before First Use!
1. Set all Input Level Controls to minimum & Tones Controls
to flat (the middle setting) before turning your system on
2. Plug lectern gooseneck microphone into the Lectern Mic
Jack located on the tabletop
3. Switch POWER to ON, the BATTERY LED will light
4. Slowly increase the Level Control for the input jacks used
to the desired volume
IMPORTANT: Make all connections with shielded cables to avoid
hum, buzzing or interference.
BACK PANEL OF ACL-7500U2+
AUXILIARY MICROPHONE
INPUT JACK – 1/4" Phone
CHARGE INDICATOR LIGHT
Balanced - low impedance microphones,
powers condenser mics
LOW BATTERY
INDICATOR LIGHT
USB PORT
FOR GOOSENECK LIGHT
POWER SWITCH
SPEAKER OUT
OUTPUT JACK – 1/4" PHONE
Balanced - drives an unpowered 6 ohm speaker
in addition to the built-in speakers
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com/cinemark/
TOP PANEL OF ACL-7500U2+
LECTERN LEVEL
WIRED MIC LEVEL
CONTROL
CONTROL
LEVEL CONTROL
LINE OUT
OUTPUT JACK – 1/4" PHONE
Balanced - provides combined
output of all active system inputs
Record presentation / connect to another
powered sound system
LINE IN
INPUT JACK – 1/4" PHONE
Jack may be combined with mic inputs
for a composite output
For playback of tape/CD player or
other audio source
MADE IN USA
SIX YEAR WARRANTY
UHF WIRELESS RECEIVER
Available on selected models only
LINE IN
WIRELESS MICROPHONE 1
WIRELESS MICROPHONE 2
LEVEL CONTROL
LECTERN
MICROPHONE
JACK
FRONT/SPEAKER
ACCLAIM LECTERN TABLETOP
LECTERN TOP
All Models
LEVEL CONTROL
2