Anchor AnchorMAN H-200S 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Anchor AnchorMAN H-200S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor AnchorMAN H-200S 6 페이지. Wireless intercom system

페이지 인쇄

RECHARGEABLE BATTERIES

AnchorMAN belt packs include 4 "AA" NiMH rechargeable batteries and AC Gang Charger. Fully charged NiMH bat-

teries yield approximately 7 hours of normal use. Alkaline "AA" batteries can be used but battery life will decrease by

half. Connecting the AC charger to a belt pack with alkaline batteries installed could seriously damage the system.

INSTALL BATTERIES

1. Slide battery compartment door to remove

2. Install 4 "AA" NiMH rechargeable batteries

NOTE: Place "–" end of battery against spring.

3. Replace battery compartment door

NOTE: Flashing Group LED indicates battery low.

CAUTION: Do not attempt to charge alkaline batteries.

Some users are required (for emergency preparedness, etc.) to leave their AnchorMAN units plugged into the charger

at all times. For these applications we recommend replacing the rechargeable batteries every 12 months.

NETWORK EXPANSION

CAN I USE MY OWN HEADSET?

The AnchorMAN is designed to work with dynamic microphone elements.

Headset pin configuration: 1 = Mic (–) / 2 = Mic (+) / 3 = Headphone (–) / 4= Headphone (+)

Shields can be connected to chassis ground pin.

I'VE RUN OUT OF BATTERY LIFE, NOW WHAT?

You can substitute "AA" alkaline batteries for the rechargeable batteries. However, connecting the battery charger to

the belt pack when alkaline batteries are installed could seriously damage your belt pack.

CAN MY ANCHORMAN WORK WITH OTHER WIRELESS INTERCOM SYSTEMS?

No. AnchorMAN uses a proprietary design and software exclusive to the product.

CAN SOMEONE EAVESDROP ON MY CONVERSATION?

No. AnchorMAN is not penetrated by common scanners.

IF I BREAK A HEADSET, WHAT DO I DO?

The H-200 and H-200S headsets are covered by a two-year warranty. Follow the instructions in the Getting Started

section on page 2 for a Return Authorization. AnchorMAN headsets are sold separately if a replacement is needed.

CAN I ADD BELT PACKS TO MY NETWORK?

Yes. The system is designed to accommodate an unlimited number of listeners. However, the maximum number of

people that can speak at once in one group is limited to four. Belt packs that are set to the same USER ID (DIP 1

and 2) and group will interfere if they transmit at the same time. However, if two users are not expected to speak at

the same time, they can share a USER ID.

CHARGE BATTERIES

1. Connect Gang Charger (included) into Charging

Port on bottom of belt packs

2. Plug Gang Charger into AC outlet

(Charging Port LED on = battery charging)

3. Charge belt pack for 5 hours

(Charging Port LED off = battery fully charged)

USING THE WINGMAN W/ ANCHORMAN

WHAT IS WINGMAN?

WingMAN is an interface station that allows full duplex communication between AnchorMAN belt packs and unbal-

anced party-line intercom systems.

The WingMAN includes a transceiver that operates in a FDMA format which is compatible with AnchorMAN belt packs.

An integrated interface circuit makes it possible to easily interface the transceiver with party-line intercom systems.

This allows users to easily switch communications between one of the four AnchorMAN groups and one of two party

line groups.

BASIC WINGMAN SETUP & OPERATION

For detailed instructions on using the WingMAN please consult the owners manual that came with the unit.

1. Attach supplied antennas to the "RX" & "TX" back panel jacks.

2. Connect your wired intercom system to the 3-pin XLR back panel jack "INTERFACE".

3. Connect DC power supply.

4. Set DIP Switch #4 to designate wired intercom system.

DIP Switch #4 Settings:

ON (DOWN) – 100 ohm systems (Anchor Audio PortaCOM)

OFF (UP)

– 200 ohm systems (Clear-Com or RTS)

5. ANCHOR AUDIO PORTACOM USERS ONLY: Select wired channel according to PIN CONFIGURATION.

6. Set GROUP knob to the AnchorMAN belt packs GROUP.

7. Turn the WingMAN power switch to ON.

8. Adjust WIRED & WIRELESS VOLUME to desired listening levels.

NOTE: AnchorMAN belt packs assigned to the same Group & Frequency as the WingMAN will

experience interference when transmitting.

WIRED VOLUME

WIRED CHANNEL SWITCH

ANCHORMAN GROUP SELECTOR

DIP SWITCH

WINGMAN FRONT &

BACK PANELS

Model Shown: WM-900

RECEIVE ANTENNA JACK

WIRELESS VOLUME

WIRED SYSTEM INTERFACE

TRANSMIT ANTENNA JACK

DC POWER JACK