Anchor BPW-300 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Anchor BPW-300에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor BPW-300 4 페이지. Anchor audio owner's manual wireless intercom system bpw-300

페이지 인쇄

1. Install batteries -

2. Select a transmission channel on the belt pack

(1 thru 16, 9 is reserved for All Call channel)

3. Plug headset connector into jack on belt pack

4. Turn on power & adjust volume w/ thumbwheel on side

5. Press PTT button once for Active Mode

6. Press & hold PTT button for Push To Talk Mode

4. Set each belt pack in a group to the same channel

Under ideal conditions the distance between belt packs can be up to 400' line

of sight. However, system performance can be affected by many external

sources. To minimize the effects of interference:

• Keep the distance between belt packs as short as possible

• Make sure that there are no obstructions between belt packs

• Maintain visual contact with all users in the group

Adjust the microphone sensitivity (gain level) to compensate for individ-

ual users voice levels and surroundings. For soft voices or when whis-

pering raise sensitivity, lower it if you need to shout.

1. Remove rubber plug on back of belt pack to access dial

2. Using a small screwdriver turn the VOX dial clockwise to

raise mic sensitivity, counterclockwise to lower

3. Replace plug to keep dirt & debris out of unit

Slow Flash: Listen Only Mode

Fast Flash: Active Mic Mode (talk or listen)

Solid On:

Transmitting/Receiving

Green:

Battery Good

Red:

Battery Low/Charging Error

Amber:

Charging Battery/All Call Mode

(plug in headset)

PortaCom PRO comes with a simple, easy to use encryption method to make certain no one can listen in on your conversations. All belt packs are shipped with the encryption settings

in the OFF position, this allows all your belt packs to operate together out of the box. Follow the instructions below to enable encryption.

1. Remove the battery compartment cover by sliding the door down

2. Locate the opening that houses eight small selection switches (see above)

3. With a small screwdriver (included) set the ON/OFF settings of the eight

switches to any pattern you desire

(set to match other belt packs)

Turn Unit On w/ Thumbwheel:

Single-Click:

Single-Click Again:

Push & Hold:

(set to channel 9 for All Call)

4. Set the same ON/OFF pattern to the switches on each belt pack in the

group so they can communicate with each other

5. Turn power for each belt pack off and back on the engage encryption

6. Test all of the units to verify that the code has been set correctly

Listen Only mode

Lock In Active Mic (talk or listen)

Switch to Listen Only Mode

Push to Talk Mode