Anchor PortaCom 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Anchor PortaCom에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor PortaCom 12 페이지. Portacom wired intercom owners manual
Anchor PortaCom에 대해서도 마찬가지입니다: 소유자 매뉴얼 (5 페이지)
페이지 인쇄WINGMAN (WM-500)
The WingMAN 500 is an interface station that allows full duplex communication between ProLink belt packs and
unbalanced party-line intercom systems. The ProLink includes a transceiver that operates in a FSK format which is
compatible with ProLink belt packs. An integrated interface circuit makes it possible to easily interface the transceiver
with party-line intercom systems. This allows users to easily switch communications between one of the two ProLink
groups and one of two party line groups.
BASIC SYSTEM OPERATION
1.
Attach the supplied antennas to the front panel jacks
2.
Connect your wired intercom system to the 3-pin XLR input on the back panel
NOTE: Operating power for the WM-500 is obtained from the wired intercom system
3.
Select wired channel A or B on front panel
4.
Select wireless channel A or B on front panel
5.
Turn power switch to ON
6.
Adjust the headset volume to desired level
WingMAN MASTER
WM-500
WingMAN MASTER
WM-500
ANTENNA JACK
HOW TO SETUP THE WIRELESS TELEX (BTR-700)
Follow the setup instructions below to connect the WingMAN 500 to a BTR-700 Telex wireless base station.
1.
Connect your BTR-700 (2-wire 3-pin XLR) output to the 3-pin XLR input on the back panel of the WM-500
2.
Set WingMAN to Wired Channel B on front panel interface
If you have questions about the compatibility of your wired or wireless intercom system and the WingMAN 500,
WIRED
CH A
CH B
WIRED
CH A
POWER SWITCH
WIRED
CHANNEL
SWITCH
CH B
XLR INPUT
please contact Anchor Audio Technical Support.
800.262.4671 x782
|
The WingMAN 500 interface connector uses a 3-pin XLR
jack on the back panel. Connect the interface box with
the wired intercom system using the 3 pin XLR jack on the
rear panel.
Pin Configuration
Select Wired Channel (A or B) to be used according to
the pin description above (also shown on pack panel) .
The Wired Channel Switch matches the Anchor Audio
PortaCom belt pack channels.
WIRELESS
CH A
CH B
WIRELESS
CH A
WIRELESS
ANTENNA JACK
CHANNEL
SWITCH
CH B
anchoraudio.com
+24V
anchoraudio.com
+24V
(OPTIONAL ACCESSORY)
PIN CONFIGURATION
PIN 2:
Wired Channel A/
System Power
PIN 1:
PIN 3:
Ground
Wired Channel B
6