Bosch 52314 작동/안전 지침 매뉴얼 - 페이지 8
{카테고리_이름} Bosch 52314에 대한 작동/안전 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 52314 44 페이지. Cordless jigsaws
Bosch 52314에 대해서도 마찬가지입니다: 작동/안전 지침 매뉴얼 (44 페이지), 부품 목록 (2 페이지), 작동/안전 지침 매뉴얼 (37 페이지)
페이지 인쇄
BLADE INSTALLATION AND REMOVAL
This jigsaw is equipped with the Bosch "Clic"
tooless blade changing system. This system
makes changing blades simple and fast.
Insert
the
saw
blade
(teeth
in
cutting
direction)
until it latches in the plunger.
When
inserting
the saw blade, the back of the blade
must
rest in the groove
of the guide
roller
(Fig. 2).
Note:
If the saw blade
cannot
be inserting
into the plunger,
the slots of the blade holder
are not positioned
as shown,
push the blade
ejector lever briefly to the front and release.
To change
the saw blade,
push the ejector
lever to the center stop; this releases
the saw
blade and it is ejected.
When changing
the blade, tool should be
held so that the blade is safely ejected.
m
EJECTOR
LEVER
PLUNGER
I
]
GUIDE
ROLLER
GUIDE
ROLLER
ATTACHING
NON-MARRING
OVERSHOE
Your tool is equipped
with a protective
plastic
overshoe
that protects
finer surfaces.
To attach,
hook overshoe
over front of metal
footplate
and
snap
into
place
at rear
of
footplate
(Fig. 3).
ANTI-SPLINTER
INSERT
To minimize
splintering
of the top surface
of
the material
being cut, place the anti-splinter
insert in the blade opening
of the footplate,
or
the non-marring
overshoe.
Note: This insert will only work with blades
that have ground sides such as T301CD,
TB1B, T101D, and T101DP.
ANTI-SPLINTER
INSERT
--]
NON-MARRING
OVERSHOE
Operating Instructions
SWITCH
LOCK
The
switch
lock
is designed
to prevent
accidental
starts. To operate switch, press the
switch
lock
button
with
your
thumb
to the
unlock _ symbol. To lock the switch, press the
switch
lock
button
to the lock
t_ symbol
(Fig. 1).
VARIABLE
SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed trigger
switch. The tool can be turned "ON" or "OFF" by
squeezing or releasing the trigger.
The speed
can be adjusted from the minimum to maximum
nameplate SPM by the pressure you apply to the
trigger.
Apply more pressure
to increase
the
speed and release pressure to decrease speed
(Fig. 1).
BRAKE
When the trigger
is released
it activates
the
electrical
brake to stop the blade quickly.
This
feature
is especially
useful
when
making
repetitive cuts.
-8-