Anchor ProLink 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Anchor ProLink에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor ProLink 4 페이지. Wireless intercom system

BASIC SETUP AND OPERATION

1. Charge the batteries 5-6 hrs.

Note: Belt packs operate about four hours of continuous use per

charge. (Diagram 2)

2. Find the MASTER belt pack as indicated on the top label. The

Master belt pack must be ON for each of the REMOTE belt packs to

function. (Diagram 1)

3. Plug headset cable into belt pack & adjust boom. (Diagram 2)

4. Turn on power and set headset volume. Power ON LED is solid green

and flashing green for LOW battery. (Diagram 1)

5. Set slide switch to Push to Talk or Always On mode.

(Diagram 3)

6. Choose channel A or B for all belt packs. If both channels are used

at the same time, two master belt packs are required (See page 6).

(Diagram 1)

Note: repeat above for each member's belt pack in use.

SYSTEM RANGE

The RF signal will travel through many solid objects. However, the more

solid objects between the belt packs, the more the range will be reduced.

When the belt packs are transmitting, the Transmit LED will flash red. If the

signal drops out, the LED will glow solid red on REMOTE belt packs only. If

the belt packs are too far apart, the REMOTE belt packs need to move closer

to the MASTER belt pack.

D I A G R A M 1

ON/OFF/VOLUME CONTROL

MIC GAIN CONTROL

POWER LED (GREEN)

PROLINK BELT PACK

Model Shown: BP-9000M

D I A G R A M 2

CHARGING LED (RED)

For videos on how to setup & use the ProLink: www.anchoraudio.com

RX/TX LED (RED)

PTT BUTTON

CHANNEL SELECTOR

PUST TO TALK OR

ALWAYS ON SLIDE SWITCH

XLR CONNECTOR

CHARGING PORT

D I A G R A M 3

BELT CLIP

BATTERY COMPARTMENT