Anchor GO GETTER 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Anchor GO GETTER에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor GO GETTER 2 페이지. Sound system
Anchor GO GETTER에 대해서도 마찬가지입니다: 소유자 매뉴얼 (9 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
SOUND SYSTEM PLACEMENT
CORRECT SYSTEM PLACEMENT
(having the micrphone too close to front of unit may cause feedback)
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
CONDITION
No Sound (power LED off)
No Sound (power LED on)
• check for output from source
• make sure all cables are completely plugged in
• turn up volume control of input used
• remove plug from speaker output if not using external
Shortened Battery Life
• charge battery fully; if battery life continues to deteriorate,
Distorted Sound
• lower system volume control
• lower input volume control
Excessive Hum or Noise
• use shielded cables
• use balanced microphone
HAVING TROUBLE WITH YOUR WIRELESS SYSTEM? (Wireless Models Only)
CONDITION
POSSIBLE SOLUTION
No Sound (RX Indicator: ON)
• turn up WIRELESS volume control
• make sure mic is plugged into body pack transmitter
No Sound (RX Indicator: OFF)
• push mic power button
• turn Go Getter POWER switch on
• make sure transmitter power switch is on
• set receiver and transmitter to same channel
• replace battery in transmitter
The Go Getter Sound System comes with a six year warranty, Anchor Audio Bluetooth comes with a six
year warranty, and all Anchor Audio batteries, CD/MP3, and wireless come with a two year warranty.
NEED MORE HELP? Go Getter Sound System Setup & Operation Videos!
Visit Our Website: www.anchoraudio.com
WRONG SYSTEM PLACEMENT
POSSIBLE SOLUTION
• turn POWER switch ON
• charge battery or plug in AC cord
• safely shut down if unit overheats, turn volume lower &
turn speaker ON
speaker output
contact Anchor Audio customer service: 800.262.4671
MADE IN THE USA
SIX YEAR WARRANTY
Quick Start Manual
GO GETTER SOUND SYSTEM
You can view a demonstration video complete with a trouble shooting section at
www.anchoraudio.com.
Please check your new unit carefully for any damage which may have occurred during shipment.
CONNECTING MULTIPLE SOUND SYSTEMS
UNPOWERED COMPANION SPEAKER
Connect one end of a speaker cable (SC-50NL) to the SPEAKER OUT jack on the back of a powered
Go Getter sound system. Connect the other end to the jack labeled IN on the back of a Go Getter
unpowered companion speaker.
NOTE: AC power is not required for an unpowered companion speaker.
POWERED SOUND SYSTEMS
This method uses the line-output feature of your Go Getter sound system. Connect a speaker
cable (1/4" phone) from the LINE OUT jack on the first powered Go Getter to the LINE IN jack on
the second powered Go Getter. Set the volume of the second Go Getter to maximum so that full
volume control will be at the first or primary sound system.
NOTE: The line-output feature can also be used to send the signal to a sound
system in a different room or a separate recording device.
Anchor Audio, Inc. • (800) 262-4671 • www.anchoraudio.com
100-0228-000 Rev. B