Anchor Acclaim 2 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Anchor Acclaim 2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor Acclaim 2 11 페이지. Portable lectern

PAIRING BUTTON

PAIRING THE ANCHORLINK WIRELESS MICROPHONES

1. Turn on Mic Receiver (volume knob clockwise) then hold Pairing button until green light for Mic 1 flashes, release button.

2. Turn on Mic then press and hold Mute button until Mic red light turns off, release button.

3. Press and hold Mute button again until Mic green light flashes.

4. The Mic is paired when the green light is solid on both the Mic and Mic Receiver.

5. Repeat these steps for Mic 2 on the same Mic Receiver (Mic 1 will stay paired through this process). If applicable, repeat these steps

for Mic 3 and 4 on Mic Receiver 2.

Note: You may pair only one microphone at a time. Each Mic Receiver included supports two wireless microphones. Two Mic Receivers = Four wireless microphones supported.

You will only need to pair your microphone once.

UNPAIR WIRELESS MICROPHONES

1. Start with the speaker On and the Mic Receiver in the Off position (volume knob turned counter-clockwise until "click").

2. Press and hold the Pairing button on the Mic Receiver.

3. While holding the Pairing button, turn on the Mic Receiver (volume knob clockwise).

4. Continue to hold the Pairing button. Lights will appear in the order listed below. Process takes approximately 25 seconds:

•

Mic 2 – Green blinking

•

No Link – Red blinking

•

Pause

•

Mic 1 – Green blinking

•

No Link – Red

5. Once the No Link red light is solid, both Mics have been unpaired.

6. Repeat these steps for the 2nd Mic Receiver (if included).

Note: This process unpairs both Mics from a Mic Receiver. The Mics are not needed to unpair from the Mic Receiver.

INDICATOR LIGHTS

VOLUME/POWER KNOB