Athena GET Hourmeter C1 사용자 설명서 - 페이지 4
{카테고리_이름} Athena GET Hourmeter C1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Athena GET Hourmeter C1 8 페이지. Athena technologies home theater subwoofer owner's manual s1, s2, s3, c1, p1, p2, p3
Athena GET Hourmeter C1에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지)
페이지 인쇄5 NORMAL USE
Switch on the engine and wait a few seconds (around 8 – 10 s). The display turns on automatically, showing
the working hours and the blinking dot.
In this condition S button is not working: it is not possible to visualize total and partial counters.
Once the engine is switched off, the counter will be active for a minute. The device will turn off automatically.
6 TOTAL COUNTER VISUALIZATION
Proceed as follow:
Push briefly S button: the display shows tot for 3-4 seconds and, after this, the total working hours value
for around 8 seconds.
At the end of this visualization the display will turn off automatically.
7 PARTIAL COUNTER VISUALIZATION
Proceed as follow:
Push briefly S button: the display shows tot for 3-4 seconds and, after this, the total working hours value
for around 8 seconds.
During the visualization, push S button briefly: display shows Par for around 3 seconds and, after this, the
partial working hours for around 8 seconds.
At the end of this visualization the display will turn off automatically.
WARNING: partial hours counter could increase differently from the total hours counter. This behaviour is
related to the moment when the reset is done. C1 visualizes tens of minutes but, in reality, internal counter is
divided in to singles minutes.
4
3 s
Hourmeter C1 – User Manual rev. 07
GET - ATHENA Spa
-
Web:
www.getdata.it
3 s
3 s