Anchorlift Aquarius 2500 사용자 설명서 및 설치 설명서 - 페이지 5

{카테고리_이름} Anchorlift Aquarius 2500에 대한 사용자 설명서 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchorlift Aquarius 2500 16 페이지. World class windlass system

Preparation:

The windlass is to be placed in the correct position by aligning the gypsy with the bow. The rope or chain needs to be

level with the deck and wound around the gypsy at an angle of about 180 degrees.

(See photo P 3)

P 3

Before drilling holes, you must check the following:

1) There are to be no obstacles below the deck. There must be enough space for the chain/rope (Rode Kit) to fall

properly 12-18 inches.

2) Make sure the top and bottom surfaces of the deck are as parallel as possible. If necessary, compensate for any

differences to prevent windlass base & gearbox from being damaged.

3) Once the ideal position has been found, place the drilling/mounting template in position and mark all the holes.

Barracuda, Dolphin & Mako models are equipped with 8mm stainless steel bolts. When installing the windlass use a

10mm drill bit for the bolt holes.

Before installing turn the windlass over and supply a suitable bead of sealant as shown below.

P 6

P 5

Installation

P 7