Carlson BRx5 빠른 시작 매뉴얼

{카테고리_이름} Carlson BRx5에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carlson BRx5 2 페이지. Base/rover
Carlson BRx5에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (5 페이지)

Using the Satel EASyPro 35W Mobile Base Radio with the

OVERVIEW:

Carlson's BRx5 GNSS receiver configured as a base can be used with Satel's SATELLINE

EASyPro 35 watt mobile base radio. This document describes a procedure for configuring the

EASyPro radio to avoid damaging the BRx5's internal UHF radio or GSM radio using SurvCE

version 4.03 or higher.

PROCEDURE:

1. Setup the BRx5 base and its tripod and the EASyPro radio antenna on its tripod. Connect the

antenna cable from the EASyPro to the EasyPro antenna. Connect the communications cable

(to the EASyPro (8 pin LEMO connector) and the BRx5 (9 pin D type male connector to the 9

pin connector on the BRx5). Plug the power cable into the EASyPro (2 pin Lemo connector) but

do not connect the red and black clips to the battery powering the EASyPro (in other words,

DON"T TURN ON THE EASyPro power).

2. Turn on the BRx5 GNSS base by holding down the power button. Run SurvCE on your data

collector. Go to Equip/Base/Comms and connect to the BRx5 base using Bluetooth.

3. Select the RTK tab. Set device to "Satel 35W", set the RTK Port to "A" and the baud rate to

"9600". This is the default value for the EASyPro radio, if you have changed the EASyPro's

baud rate, you will need to set the baud rate in SurvCE to the same baud rate as the EasyPro.

4. Tap the green check. This will configure the BRx5 for the EASyPro radio. Tap the red X to

skip setting the base position, this position will be set later in the configuration process.

5. Look at the control panel LEDs on the BRx5. The left-most LED should be off, indicating that

the BRx5's internal UHF radio and GSM cell modem are both powered off. Press the select

button the BRx5 and the LED display will be similar to this:

6. The most important LED is the left most LED. It should be OFF. If it is not powered off, repeat

steps 2 and 3. DO NOT CONTINUE to step 7 if the left-most LED is ON, as you may damage

the BRx5 internal UHF radio or GSM cell modem.

This document contains confidential and proprietary information that remains the property of Carlson Software Inc.

Page 1 of 2

Carlson BRx5 GNSS Receiver

Released: January 29, 2015

Carlson Software Inc.

102 West 2

Street

Maysville, KY 41056

www.carlsonsw.com

Phone: (606) 564-5028

Fax: (606) 564-6422

Updated 6/18/2015