Athena 4000 Series 운영 매뉴얼 - 페이지 5

{카테고리_이름} Athena 4000 Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Athena 4000 Series 16 페이지. Temperature/process controller

Wiring

Typical Wiring Diagrams for -T & -B Outputs

B-Type -

840 W maximum. 120 Vac heater. (Non-inductive loads only) For larger loads, replace heater connections

with contactor, as required. Maximum inductive load rating is 3 A at 120 V and 1.5 A at 240 V. The N.C.

contacts can be used for cooling.

terminal 10 and fuse both of the supply legs.

T-Type -

CAUTION

solid state relay with SPST contacts. The -T units can handle contactors or resistive loads up to 1 A with 10 A

Possible fire hazard.

inrush maximum. For -T units use a 1 A, 250 V fast blow fuse.

Because these

controls or associated

equipment may not

always fail safe, an

approved temperature

and/or pressure

safety control should

be used for safe

operation.

For 240 Vac supply move the connection shown on terminal 9 to

Note:

Figure 2. Typical 120 Vac for -B & -T Output