Athena 6050 사용 설명서 - 페이지 6

{카테고리_이름} Athena 6050에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Athena 6050 15 페이지.

Loss of power or turn-off during warm-up requires a

re-start from ambient.

Change of state processes, i.e. solid to liquid or

liquid to gas, may introduce erroneous tuning parameters

during process warm-up.

GENERAL

1. Accurately measures, linearizes and displays temperature

in °F and °C.

2. Automatically calculates and displays parameters-heat

gain, and rate/reset time.

3. Can be field converted from relay output

state relay "T", to solid state driver "S" or to

a 4-20 MA output SCR driver "F".

4. Will remember its "entered" settings after power failure

or shut-off and not "Go To Sleep".

CAUTION: HIGH VOLTAGE AN0 HIGH TEMPERATURES CAN CAUSE INJURY

AN0 ARE A FIRE HAZARO. PLEASE REAO ALL INSTRUCTIONS, HAVE

ONLY SKILLED PROFESSIONALS WIRE THE UNIT, AND USE APPROVED

TEMPERATURE AND/OR PRESSURE SAFETY CONTROL. EVEN THE BEST

COMPONENTS CAN BE DAMAGED OR MAY NOT FAIL SAFE.

CONFIGURATION

Depending on the model number of the unit you have ordered,

vou will find one of four basic modules installed. The fifth

digit of the code indicate the output module type.

B - Relay 7A/5A @ 120/240 Vac

F - 4-20 mA (Proportional)

T - Triac 1 Amp @ 240 Vac

S - 20 VDC Pulsed for driving solid state relays

Example: 6050-F has proportional 4 to 20 mA heat

output.

Note: If you have not received your controller from the

factory direct, check to confirm that the correct module for

your application is installed. Since the modules plug-in,

and since controller plug into cases as well, previous users

may have changed modules, which can result in severe

controller damage.

"B", to solid